WORKPLACE FOR MANUAL HAIRPIN COIL INSERTION INTO DC MOTOR ARMATURE STACKS (ACM150) |
||
The ACM150 workplace is built on a solid wood table top, on which is
fixed a steel plate, carrying the armature seat cup that can be freely
rotated by hand for easy coil arrangement. A piece of guiding
grooves for the coil ends is fixed at the cup bottom with a hollow
shaft in the middle, on which is shifted vertically a disc with steel
pins, used to support the coils during their arrangement. This disc is
retained in upper position during the coil arrangement by a spring
retainer. The lifting of the disc together with the retaining pins is
done manually by pulling a vertical lever with handle. |
||
# | Parameter |
Value |
1 |
Maximum armature stack diameter , (mm) |
90 |
2 |
Maximum armature shaft length, (mm) |
223 |
3 |
Pneumatic cylinder pressing force during installation , (N) |
2500 |
4 |
Maximum stroke of the pressing-in mechanism, (mm) |
320 |
6 |
Air pressure supply, (bar) |
5 |
7 |
Power, (V) |
220/380V/50Hz |
10 |
Overall dimensions , (mm) |
500/784/1964 |
11 |
Weight , (kg) |
140 |
www.ameka.bg |